Start a conversation

LR III | Cleaning Your Litter-Robot Open Air

Litter-Robot Open Air: Cleaning and Maintenance

Litter-Robot Open Air is made with standard plastics. The liner is made out of PVC. We recommend cleaning the unit as needed. Simply wiping it down with a damp paper towel will keep your unit looking new and clean. Using a mild detergent is recommended. Do not use bleach on the units as this can cause the plastic to degrade. Common household cleaners can be used, again, avoid bleach and do not spray directly onto the unit.

The globe should be fully cleaned twice a year. The base can be wiped down with a dry or damp cloth as needed. Turn off the unit and unplug the unit from the wall prior to any deep cleaning.

There are no electronics in the Globe or waste drawer so you can soak these a tub or hose them down. While the globe and waste drawer are dry, you can use a vacuum to remove excess dry litter. This will help prevent litter streaking. We like to use a soft toilet brush to easily access the inside of the Globe. Once you're finished cleaning the Globe, be sure that it is completely dry before adding litter.

Do not submerge the base or bonnet in water. We highly recommend cleaning these with a damp rag or paper towel. Avoid any of the electronics or metal pieces. Again, do not spray any liquids directly onto the base or bonnet to avoid damaging the electronics. If you find excess build-up of litter you can vacuum it up prior to wiping it down to avoid litter streaking.

While wiping down the base, we recommend checking your DFI lenses. These are located just inside the waste opening on the base of the unit. If you see any residue on the clear plastic, wipe it off and make sure that the lenses are clean. Debris may cause the DFI to indicate a full drawer regardless of the waste in the drawer.

Once you are done cleaning your unit, let it dry fully then reassemble it. If it is not dry the litter will clump prematurely and may get clogged in the ports or litter pocket. Add your litter to the fill ridge line and let the unit complete an initial cycle. This will ensure that the automated cat sensor (CATS) is ready for your cat's next visit.

Videos:

How to clean your Litter-Robot

We also recommend checking out these articles:

Litter-Robot Open Air Assembly Instructions | Litter-Robot Open Air Knowledgebase

www.litter-robot.com | www.kittyagogo.com | www.feed-safe.com | www.kittyplayzone.com 

Choose files or drag and drop files
Was this article helpful?
Yes
No
  1. Leigh E

  2. Posted
  3. Updated

Comments